Kia Soul: Rear Washer Motor Inspection - Rear Wiper/Washer - Body Electrical SystemKia Soul: Rear Washer Motor Inspection

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Washer Motor Inspection

1.
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
  
Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter.
2.
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
3.
Connect positive (+) and negative (-) battery cables to terminals 1 and 2 respectively to see that the washer motor runs and water is pumped.
4.
Check that the motor operates normally.
Replace the motor if it operates abnormally.

    Rear Washer Switch Inspection
    1. Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch. ...

    See also:

    Installtion
    1. With a knife, scrape the old adhesive smooth to a thickness of about 2mm (0.08 in.) on the bonding surface around the entire windshield opening flange: ...

    Fan speed control
    The ignition switch must be in the ON position for fan operation. The fan speed knob allows you to control the fan speed of the air flow from the ventilation system. To change the fan speed, turn ...

    TPMS Sensor Mode of Operation
    ASIC Mode 1. Factory Mode The factory mode is the mode that allows the TPM sensor to transmit RF Frames and sample LF more often in the HKMC factory. T ...