Kia Soul: Audio Remote Control Inspection - Audio - Body Electrical SystemKia Soul: Audio Remote Control Inspection

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Audio / Audio Remote Control Inspection

1.
Check for resistance or output voltage between terminals in each switch position.
[Audio]

Switch
 Connector terminal
 Resistance (±5%)
 Output voltage
Seek up
 2-4
 430 Ω
 0.4 V ± 0.22
Seek down
 2-4
 1.1 kΩ
 1.0 V ± 0.22
Mode
 2-4
 2.11 kΩ
 1.5 V ± 0.22
Mute
 2-4
 3.11 kΩ
 2.0 V ± 0.22
Volume up
 2-4
 4.61 kΩ
 2.5 V ± 0.22
Volume down
 2-4
 6.81 kΩ
 3.0 V ± 0.22

[Cruise]

Switch
 Connector terminal
 Resistance (±5%)
 Output voltage
Cancel
 2-4
 180 Ω
 0.8 V ± 0.17
Set
 2-4
 330 Ω
 1.2 V ± 0.17
Resume
 2-4
 550 Ω
 1.8 V ± 0.22
Cruise
 2-4
 880 Ω
 2.3 V ± 0.22
Speed limit
 2-4
 2.54 kΩ
 3.6 V ± 0.22

[Voice + Bluetooth]

Switch
 Connector terminal
 Resistance (±5%)
 Output voltage
Voice
 2-4
 10.71 kΩ
 3.5 V ± 0.22
Call off
 2-4
 18.91 kΩ
 4.0 V ± 0.22
Call
 2-4
 40.91 kΩ
 4.5 V ± 0.22

[Flex steer + Trip + Reset]

Switch
 Connector terminal
 Resistance (±5%)
 Output voltage
Flex steer
 2-4
 180 Ω
 0.8 V ± 0.17
Trip
 2-4
 330 Ω
 1.2 V ± 0.17
Reset
 2-4
 550 Ω
 1.8 V ± 0.22

    Audio Remote Control Circuit Diagram
    ...

    Audio Remote Control Removal
    [Upper Steering Wheel Remote Control Switch] 1. Disconnect the negative (-) battery terminal. 2. Remove the driver airbag module. (R ...

    See also:

    Floor mat anchor(s)
    When using a floor mat on the front floor carpet, make sure it attaches to the floor mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward. WARNING - After market floor mat ...

    Radial-ply tires
    Radial-ply tires provide improved tread life, road hazard resistance and smoother high speed ride. The radial- ply tires used on this vehicle are of belted construction, and are selected to comple ...

    Temperature Control Actuator Inspection
    1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the t ...