•
|
Put on gloves to protect your hands.
|
|
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
•
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Remove the luggage side trim.
(Refer to Interior Trim - "Luggage Side Trim")
|
2. |
After loosening the mounting bolts, then remove the rear pillar
trim (A).
|
3. |
Install in the reverse order of removal.
• |
Replace any damaged clips.
|
|
|
See also:
Brake/clutch (if equipped) fluid
Check the brake fluid level in the brake fluid reservoir. The level should be
between “MIN” and “MAX” marks on the side of the reservoir. Use only hydraulic brake
fluid conforming to DOT 3 ...
ETC (Electronic Throttle Control) System. Repair procedures
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output v ...
Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST : For a single wiping cycle, push the lever upward and release it with the
lever in the OFF position. The wipers will operate conti ...