Kia Soul: ETC (Electronic Throttle Control) System. Repair procedures - Engine Control System - Engine Control / Fuel SystemKia Soul: ETC (Electronic Throttle Control) System. Repair procedures

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System. Repair procedures

Inspection

Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Specification: Refer to “Specification”
ETC Motor
1.
Turn the ignition switch OFF.
2.
Disconnect the ETC module connector.
3.
Measure resistance between the ETC module terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
55555

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the resonator and the air intake hose.
(Refer to Engine Mechanical System - “Air Cleaner”)
3.
Disconnect the ETC module connector (A).
4.
Disconnect the coolant hoses (B) and vapor hose (C).
5.
Remove the mounting bolts (D), and then remove the ETC module from the engine.

Installation

  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Install in the reverse order of removal.
Electronic throttle body mounting bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Adjustment

ETC module learning procedure
When installing new ETC module or re-installing it, ETC module learning procedure must be performed.
1.
Hold the ignition key or the start button at the IG ON position during 5 seconds.
2.
Turn ignition swich OFF and then start the engine.
  
DTC codes (P0638, P2110) might be displayed if ETC module learning procedure does not performed after replacing ETC module.
    ETC (Electronic Throttle Control) System. Schematic Diagrams
    Circuit Diagram (M/T) (A/T) ...

    Manifold Absolute Pressure Sensor (MAPS). Description and Operation
    Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog ...

    See also:

    Transmitter precautions
    • The transmitter will not work if any of the following occurs: - The ignition key is in the ignition switch. - You exceed the operating distance limit (about 90 feet [30 m]). - The battery in th ...

    Using the Tire Mobility Kit
    1. Detach the speed restriction label (0) from the sealant bottle (1), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too ...

    Front Washer Motor Inspection
    1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water.    ...