•
|
In order to remove the rear glass, use the tools shown
in the following figure:
[Tooling Diagram]

Square wire
Insert-type wire grip
[Tooling Assembly Diagram]
|
|
1. |
Remove the movable glass.
(Refer to Panorama Sunroof - "Movable Glass")
|
2. |
Remove the roof side moulding.
(Refer to Body Side Moulding - "Roof Side Moulding")
|
3. |
Pull the square wire (A) to the left and right, then apply a force
in the direction of the arrow to cut off the residual sealant.
• |
Longer wires require more power, so divide Section
and
in half to cut off residual
sealant.
|
|
• |
Make sure that you put on gloves to protect your
hands from potential injury.
|
• |
Be careful about potentially burning your hands
due to the heat generated from the wire in use.
|
• |
Be careful when working with wiring because it
may be cut.
|
|
• |
Be careful not to damage the body.
|
|
• |
Make sure that two or more people work together
when using wires.
|
|

|
4. |
Remove the rear glass (A) carefully without damaging it.

|
•
In order to mount the front glass, use the tools shown
in the following figure:
...
•
In order to mount the rear glass, use the tools shown
in the following figure:
...