Kia Soul: Rear combination light bulb replacement
(1) Tail light and side marker
(2) Rear turn signal light
(3) Back-up light
(4) Stop and tail light
(5) Tail light
(6) Tail/Stop light and side marker (LED)
1. Open the tailgate.
2. Loosen the light assembly retaining screws with a philips head screwdriver.
3. Remove the rear combination light assembly from the body of the vehicle.
Tail light and side marker, Turn signal light and Stop and tail light
4. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.
5. Remove the bulb from the socket by pressing it in and rotating it counterclockwise until the tabs on the bulb align with the slots in the socket.
6. Insert a new bulb by inserting it into the socket and rotating it until it locks into place.
7. Install the socket in the assembly by aligning the tabs on the socket with the slots in the assembly and turning the socket clockwise.
8. Reinstall the light assembly to the body of the vehicle.
Back-up light
Follow the steps 1 to 3 from the previous page.
4. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.
5. Pull the bulb out of the socket.
6. Insert a new bulb into the socket.
7. Install the socket into the assembly by aligning the tabs on the socket with the slots on the assembly and turning the socket clockwise.
8. Reinstall the light assembly to the body of the vehicle.
Side repeater light bulb Type B replacement (if equipped)
If the light bulb is not operating, have the vehicle checked by an authorized
Kia dealer. ...
High mounted stop light replacement
1. Open the tailgate.
2. Remove the cover.
3. Loosen the retaining bolts.
Bulb type
4. Pull out the module from the high mounted stop light assembly by pulling both
clips.
5. Replace th ...
See also:
Inner Condenser Repair procedures
Replacement
•
Be sure to read and follow the “General Safety Information
and Caution” before doing any work related with the high voltage
system. Failu ...
Illuminated ENGINE START/STOP button
Whenever the front door is opened, the ENGINE START/STOP button will illuminate
for your convenience. The light will go off after about 30 seconds when the door
is closed. ...
Transaxle Oil Temperature Sensor. Description
Transaxle oil temperature sensor monitors the automatic transaxle fluid's
temperature and conveys the readings to TCM. It is an NTC (Negative Thermal
Coefficient) sensor whose resistance ...