Kia Soul: Rear Coil Spring Replacement - Rear Suspension System - Suspension SystemKia Soul: Rear Coil Spring Replacement

Kia Soul 2014-2019 PS Service Manual / Suspension System / Rear Suspension System / Rear Coil Spring Replacement

1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from front hub.
Tightening torque :
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

  
•
Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).
3.
Loosen the bolt and then remove the rear shock absorber (A) from the torsion beam axle.
Tightening torque :
98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

4.
Pull the torsion beam axle in the direction of a down and then remove the coil spring (A).
5.
Installation is the reverse of removal.
    Rear Coil Spring Components
    1. Spring lower pad 2. Spring 3. Spring upper pad ...

    Rear Coil Spring Inspection
    1. Check the coil spring for crack and deformation. 2. Check the coil spring pad for damage and deformation. ...

    See also:

    ESC OFF Switch. Removal
    1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer to Body - &q ...

    Seat Belt Buckle Switch (BS). Components
    ...

    TPMS Receiver Description
    1. Mode (1) Virgin State A. The receiver as a sole part is shipped in this state. ...