Kia Soul: Passenger Airbag (PAB) Module. Installation - Airbag Module - RestraintKia Soul: Passenger Airbag (PAB) Module. Installation

Kia Soul 2014-2019 PS Service Manual / Restraint / Airbag Module / Passenger Airbag (PAB) Module. Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable from battery and wait for at least thirty seconds before beginning work.
3.
Place a passenger airbag on the crash pad and tighten the passenger airbag (A) mounting bolts.

4.
Install the crash pad.
(Refer to Body - "Main crash pad assembly")
5.
Connect the passenger airbag connector (B).

6.
Tighten the passenger airbag mounting bolts (A).

Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

7.
Reinstall the glove box housing.
(Refer to Body - "Glove box housing")
8.
Reconnect the battery negative cable.
9.
After installing the passenger airbag (PAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
    Passenger Airbag (PAB) Module. Removal
    1. Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. 2. Remove the glove box housing. ...

    Side Airbag (SAB) Module. Description
    The Side Airbags (SAB) are installed inside the front seat and protect the driver and front passenger from danger when side crash occurs. The SRSCM determines deployment of side airbag by usi ...

    See also:

    Components
    1. Front pillar trim 2. Cowl side trim 3. Center pillar lower trim 4. Center pillar upper trim 5. Rear pillar trim 6. Front door scuff trim 7. Rear door scuff trim ...

    Headlight, position light, turn signal light, side marker light and front fog light bulb replacement
    (1) Headlight (High) (2) Headlight (Low) (3) Front side marker light (4) Front turn signal/Position light (5) Front fog light (if equipped) If the headlight aiming adjustment is necessary after ...

    Fuel Pressure Control Valve. Repair procedures
    Inspection 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the fuel pressure regulator valve ...