Kia Soul: On-board Refueling Vapor Recovery (ORVR) valve Removal - Evaporative Emission Control System - Emission Control SystemKia Soul: On-board Refueling Vapor Recovery (ORVR) valve Removal

Kia Soul 2014-2019 PS Service Manual / Emission Control System / Evaporative Emission Control System / On-board Refueling Vapor Recovery (ORVR) valve Removal

1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump.
(Refer to Fuel System - "Fuel Pump")
3.
Remove the ORVR (A) after releasing hooks (B).

    Canister Installation
    1. Install in the reverse order of removal. Canister mounting bolt: 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft) ...

    On-board Refueling Vapor Recovery (ORVR) valve Installation
    1. Install in the reverse order of removal. ...

    See also:

    Condenser Repair procedures
    Inspection 1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdriver or pliers. ...

    Engine compartment fuse replacement
    1. Turn the ignition switch and all other switches off. 2. Remove the fuse panel cover by pressing the tab and pulling the cover up. 3. Check the removed fuse; replace it if it is blown. To remove ...

    TJ Joint Installation
    1. Wrap tape around the driveshaft spline(TJ) to prevent damage to the boot. 2. Using the alignment marks (D) made during disassembly as a ...