Kia Soul: Master Cylinder. Installation
Master Cylinder assembly
1. |
Install in the reverse order of removal.
|
2. |
After installing, bleed the brake system.
(Refer to Brake system bleeding)
|
3. |
After be equipped perform bleeding air procedure in clutch release
cylinder after pouring the brake fluid.
(Refer to Clutch - "Clutch Release Cylinder") - [MT only]
|
Master Cylinder Reservoir
1. |
Install in the reverse order of removal.
|
2. |
After installing, bleed the brake system.
(Refer to Brake system bleeding)
|
3. |
After be equipped perform bleeding air procedure in clutch release
cylinder after pouring the brake fluid.
(Refer to Clutch - "Clutch Release Cylinder") - [MT only]
|
Master Cylinder. Removal
Master Cylinder assembly 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the ECM. (Refer ...Brake Line. Components
When installing brake hose, be sure to comply with the torque specification to prevent twisted hose. ...See also:
Water Temperature Control Assembly Components
1. Water temperature assembly
2. Water temperature sensor
3. Gasket
4. Heater pipe
...
Checking the tire inflation pressure
1.After driving approximately 4 ~6miles(7~10km or about 10min), stop at a safety
location.
2.Connect connection hose (9) of the compressor directly to the tire valve.
3.Plug the compressor power c ...
Automatic climate control system
1. Turn the ignition switch to the ON position.
2. Select the defrost position pressing defrost button ().
3. While holding the air conditioning button (A/C) pressed, press the air intake
contro ...