Kia Soul: Luggage Side Trim Replacement - Interior Trim - Body (Interior and Exterior)Kia Soul: Luggage Side Trim Replacement

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Interior Trim / Luggage Side Trim Replacement

  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Remove the rear seat back assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
3.
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
4.
Remove the rear transverse trim.
(Refer to Interior Trim - "Rear Transverse Trim")
5.
After loosening the mounting bolts, then remove the rear seat lower side bracket (A) [LH,RH].
55555
6.
Slighty remove the rear door body side weatherstrip.
7.
Slighty remove the tail gate weatherstrip.
8.
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

9.
After loosening the mounting screws, then remove the luggage side trim (A).
10.
Install in the reverse order of removal.
  
•
Make sure the connector are connected in properly.
•
Replace any damaged clips.
    Luggage Side Trim Component Location
    1. Luggage side trim ...

    Rear Pillar Trim Component Location
    1. Rear pillar trim ...

    See also:

    Rail Pressure Sensor (RPS). Repair procedures
    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...

    Hood Weatherstrip Replacement
    1. Remove the glue on end of both sides (A) of the hood weatherstrip (B).    ...

    Valve Body. Removal
    1. Remove the under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover") 2. Remove the drain plug (A) and dr ...