Kia Soul: Inspection - Multifunction Switch - Body Electrical SystemKia Soul: Inspection

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Multifunction Switch / Inspection

Lighting Switch Inspection
1.
With the multi function switch in each position, make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function switch

Lighting switch (Auto light)

Lighting Switch

Dimmer And Passing Switch

Turn Signal Switch

Fog Lamp

Wiper And Washer Switch Inspection
1.
With the multi function switch in each position, make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function switch.

Wiper Switch

Washer Switch

Rear Wiper Switch

Rear Washer Switch

    Installation
    1. Install the multifunction switch. 2. Install the clock spring. 3. Install the stee ...

    Inspection (With GDS)
    1. Check IPM input/output specification of multifunction switch using the GDS. If the specification is abnormal, replace the lamp or wiper switch. ...

    See also:

    Mode Control Actuator Description
    The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing ...

    Passenger Airbag (PAB) Module. Installation
    1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable from battery and wait for at least thirty seconds bef ...

    Hood Latch Release Handle Component Location
    1. Hood latch release handle ...