Kia Soul: Inspection
Clutch cover assembly |
1. |
Check the diaphragm spring end for wear and uneven height.
|
2. |
Check the pressure plate surface for wear, cracks and color change.
|
3. |
Check the rivets for looseness and replace the clutch cover assembly
if necessary.
|
Clutch disc assembly |
1. |
Check the clutch facing for loose rivets, uneven contact, deterioration
due to seizure, adhesion of oil, or grease, and replace the clutch disc
if defective.
|
2. |
Check for the torsion spring play and damage and if defective,
replace the clutch disc.
|
3. |
Measure the depth from a clutch lining surface to a rivet. If
the measured value is less than the specification below, replace it.
|
Removal
1. Remove the transaxle assembly. G 1.6 GDI (Refer to Manual Transaxle System - " Manual Transaxle") G 2.0 GDI (Refer to Manual Transaxle System - &qu ...Installation
If reinstalling used cover, the cover should be installed with its clutch disc as a set. 1 ...See also:
Condenser Replacement
1.
Recover the refrigerant with a recovery/recycling/charging station.
2.
Disconnect the negative (-) battery terminal.
3.
...
Output Speed Sensor. Description
The output speed sensor is a vital unit that measures the rate of rotation
of the transaxle's turbine shaft and output shaft, and delivers the readings
to the TCM. The sensor provides cri ...
Vehicle handling instructions
As with other vehicles of this type, failure to operate this vehicle correctly may result in loss of control, an accident or vehicle rollover.
Specific design characteristics (higher ground clearanc ...