Kia Soul: Input Speed Sensor. Removal - Automatic Transaxle Control System - Automatic Transaxle SystemKia Soul: Input Speed Sensor. Removal

Kia Soul 2014-2019 PS Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Input Speed Sensor. Removal

1.
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
2.
Disconnect the input & output speed sensor connector(A).
3.
Remove the input & output speed sensor (B) after removing the bolts(2ea).

Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    Input Speed Sensor. Inspection
    1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

    Input Speed Sensor. Installation
    1. Install in the reverse order of removal.    • ...

    See also:

    Front fog light (if equipped)
    Fog lights are used to provide improved visibility when visibility is poor due to fog, rain or snow, etc. The fog lights will turn on when the fog light switch (1) is turned to the on position ...

    Engine compartment fuse replacement
    1. Turn the ignition switch and all other switches off. 2. Remove the fuse panel cover by pressing the tab and pulling the cover up. 3. Check the removed fuse; replace it if it is blown. To remo ...

    Description
    EPS (Electric power steering, Column assist type) system uses an electric motor to assist the steering force and it is an engine operation independent steering system. EPS control module ...