Kia Soul: Front Washer Motor Inspection
1. |
With the washer motor connected to the reservoir tank, fill
the reservoir tank with water.
|
2. |
Connect positive (+) battery cables to terminal 1 and negative
(-) battery cables to terminal 2 respectively.
|
3. |
Check that the motor operates normally and the washer motor
runs and water sprays from the front nozzles.
|
4. |
If they are abnormal, replace the washer motor.
|
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Drain the washer fluid less than 600 cc.
|
3. |
Check for continuity between the No. 1 and No.2 terminal in
each float position.
There should be continuity when the float is down.
There should be no continuity when the float is up.
|
4. |
If the continuity is not as specified, replace the washer
fluid level switch
|
Front Wiper Motor Inspection
Speed Operation Check
1.
Disconnect the connector (A) from the wiper motor.
2.
Attach the positive (+) lead from ...
Front Washer Motor Removal
-
When servicing the washer pump, be careful not to
damage the washer ...
See also:
Positive Crankcase Ventilation (PCV) Valve Installation
1.
Install in the reverse order of removal.
PCV Valve:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
...
Troubleshooting Guide
Troubleshooting (Step type)
Symptom
Suspected area
Repairment
Pressing power switch does not turn on system
Radio receiver ...
Rear Oil Seal Installation
1.
Install the rear oil seal.
(1)
Apply engine oil to a new oil seal lip.
(2)
Using th ...