Kia Soul: Front Seat Cushion Cover Replacement - Front Seat - Body (Interior and Exterior)Kia Soul: Front Seat Cushion Cover Replacement

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Cushion Cover Replacement

  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front seat shield inner cover.
(Refer to Front Seat - "Front Seat Shield Inner Cover")
2.
Remove the front seat shield outer cover.
(Refer to Front Seat - "Front Seat Shield Outer Cover")
3.
Remove the front seat lower protector (A).
4.
Disconnect the connectors (A).
5.
Detach the air ventilation seat cushion duct (B) by pulling the lock pin (A).
6.
Pull out the hooks (A), and then front seat cushion cover (C) from the front seat cushion frame (B).
7.
Remove the front seat cushion cover (A) from the front seat cushion frame.
8.
After removing the velcro tape (A) and hog-ring clips (B) on the front of seat cushion and remove the front seat cushion cover (C).
9.
Install in the reverse order of removal.
  
•
To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).
•
Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).

    Front Seat Cushion Cover Component Location
    1. Front seat cushion cover ...

    Front Seat Frame Assembly Component Location
    1. Front seat back frame assembly 2. Front seat cushion frame assembly ...

    See also:

    Rear Door Outside Handle Replacement
    1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Remove the hole plug (A). 3. ...

    Idler Removal and Installation
    1. Remove the drive belt. (Refer to Timing System - "Dreve Belt") 2. Remove the idler(A). Tightenin ...

    Manual transaxle operation
    The manual transaxle has 6 forward gears. This shift pattern is imprinted on the shift knob. The transaxle is fully synchronized in all forward gears so shifting to either a higher or a lower gea ...