Kia Soul: Front Seat Back Cover Replacement - Front Seat - Body (Interior and Exterior)Kia Soul: Front Seat Back Cover Replacement

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Back Cover Replacement

  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Push the lock pin (B), remove the front seat headrest (A).
3.
Remove the front seat lower protector (A).
4.
Push the lock pins (B) from the front seat back board (A).
  
•
Push the middle area of clip using the flat head screwdriver.
•
Be careful not to damage the lock pins.

5.
Disconnect the connectors (A).
6.
Detach the air ventilation seat back duct (B) by pulling the lock pin (A).
7.
Pull out the hooks (A) by the front seat back frame.
8.
Remove the protectors (A) on both sides.
9.
Turn the front seat back cover inside out. Then pull out the headrest guides (A) while pinching both side of the lower part of the guides, and remove them.
10.
Remove the front seat back cover (A) from the front seat back frame.
11.
After removing the velcro tape (A) and hog-ring clips (B) on the front of seat back and remove the front seat back cover (C).
12.
Install in the reverse order of removal.
  
•
To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).
•
Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).

    Front Seat Back Cover Component Location
    1. Front seat back cover ...

    Front Seat Cushion Cover Component Location
    1. Front seat cushion cover ...

    See also:

    Center Pillar Trim Component Location
    1. Center pillar lower trim 2. Center pillar upper trim ...

    Exhaust Manifold Components
    1. Heat protector 2. Exhaust manifold 3. Gasket 4. Exhaust manifold stay ...

    Purge Control Solenoid Valve (PCSV). Description and Operation
    Description Purge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister and the intake manifold. It is a solenoid valve and is open when ...