Kia Soul: Front Door Module Replacement - Front Door - Body (Interior and Exterior)Kia Soul: Front Door Module Replacement

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Front Door / Front Door Module Replacement

1.
Remove the front door window glass.
(Refer to Front Door - "Front Door Window Glass")
2.
Remove the front door outside handle.
(Refer to Front Door - "Front Door Outside Handle")
3.
Disconnect the front door main connector (A).

4.
Loosen the front door outside handle base mounting bolt (A).

5.
Disconnect the outside rear view mirror connector (A).

6.
Loosen the front door latch (B) mounting screws.
7.
After loosening the mounting bolts, then remove the front door module (A).

Tightening torque :
Bolt : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Screw : 7.8 ~ 10.8 N.m (0.8 ~ 1.1 kgf.m, 5.8 ~ 8.0 lb-ft)

8.
Remove the front door main connector mounting clips (A).

9.
Remove the front door module wiring harness mounting clips (A).

10.
Disconnect the front door latch connector (A) and then remove the mounting clip (B).

11.
Disconnect the connectors and front door module wiring harness (A).

12.
Remove the front door latch assembly.
(Refer to Front Door - "Front Door Latch")
13.
Reomove the front speaker .
(Refer to Body Electrical System - "Speakers")
14.
Remove the front power window motor.
(Refer to Body Electrical System - "Power Window Motor")
15.
Install in the reverse order of removal.
  
•
The area of whole parts should be applied with sufficient grease.
•
Make sure connectors are connected properly and each rod is connected securely.
•
Make sure the door locks/unlocks and opens/closes properly
    Front Door Module Component Location
    1. Front door module ...

    Front Door Outside Handle Component Location
    1. Front door outside handle ...

    See also:

    Body Panel Gaps
    * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

    Torque Converter Control Solenoid Valve (T/CON_VFS). Inspection
    1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector (A). 3. Measure resistance bet ...

    Driving in flooded areas
    Avoid driving through flooded areas unless you are sure the water is no higher than the bottom of the wheel hub. Drive through any water slowly. Allow adequate stopping distance because brake perfo ...