Kia Soul: ESC Control Module. Installation
Kia Soul 2014-2019 PS Service Manual / Brake System / ESC(Electronic Stability Control) System / ESC Control Module. Installation
1. |
Install in the reverse order of removal.
|
2. |
Tighten the HECU mounting bolts and nuts to the specified torque.
|
3. |
After installation, bleed the brake system.
(Refer to ABS bleeding)
|
4. |
When you have replaced the HECU always perform variant coding.
|
Variant coding
1. |
Connect the GDS to the data link connector.
|
2. |
Turn the ignition "ON".
|
3. |
Select vehicle name and system.
|
4. |
Select the variant coding.
|
5. |
Perform variant coding according to the instructions on the screen.
|
6. |
Ignition "OFF" and then ignition "ON".
|
7. |
The variant coding is completed.
|
ESC Control Module. Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the ECM.
(Refer to Engine Control / Fuel Syst ...
Front Wheel Speed Sensor. Components
1. Front wheel speed sensor
2. Front wheel speed sensor connector
...
See also:
Front Stabilizer Bar Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the front stabilizer bar for deformation.
...
Rear Seat Belt Retractor Repair procedures
Replacement
•
When installing the belt, be careful not to damage the retractor.
1.
Remove the rear pillar trim.
(Refer to Interior Trim - "Rear Pillar ...
ETC (Electronic Throttle Control) System. Schematic Diagrams
Circuit Diagram
(M/T)
(A/T)
...