Kia Soul: Cylinder Head Cover Installation - Cylinder Head Assembly - Engine Mechanical SystemKia Soul: Cylinder Head Cover Installation

Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Cylinder Head Assembly / Cylinder Head Cover Installation

1.
Install the cylinder head cover (A) with a new gasket (B).

  
Do not reuse the disassembled gasket.
2.
Tighten the cylinder head cover bolts (A) with the order and steps.

Tightening torque :
1st step: 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
2nd step: 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

3.
Install the other parts in reverse order of removal.
    Cylinder Head Cover Removal
    1. Remove the engine cover. 2. Disconnect the battery negative terminal. 3. Disconnect the control wiring harne ...

    CVVT & Camshaft Components
    1. Exhaust camshaft 2. Intake camshaft 3. Exhaust CVVT 4. Intake CVVT 5. Camshaft bearing cap 6. Camshaft front bearing cap 7. O-ring 8. OCV (Oil Control Valve) a ...

    See also:

    Power brakes
    Your vehicle has power-assisted brakes that adjust automatically through normal usage. In the event that the power-assisted brakes lose power because of a stalled engine or some other reason, you ...

    Seat warmer (if equipped)
    The seat warmer is provided to warm the front seats during cold weather. With the ignition switch in the ON position, push either of the switches to warm the driver's seat or the front pass ...

    Preset SEEK
    Press the ~   key Briefly pressing the key (under 0.8 seconds): Plays the frequency saved in the corresponding key. Pressing and holding the key (over 0.8 seconds): Pressing and h ...