Kia Soul: Rear Seat Assembly Replacement - Rear Seat - Body (Interior and Exterior)Kia Soul: Rear Seat Assembly Replacement

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Assembly Replacement

[Rear seat back assembly]
1.
Detach the rear seat belt lower anchor (C) by pushing the lock pin (B) of center mini buckle (A) with flat-tip driver.

2.
Fold the rear seat back assembly.
3.
Remove the center hinge cover (A).
4.
Loosen the rear seat back mounting bolt (A).
Tightening torque :
16.7 ~ 25.5N.m (1.7 ~ 2.6kgf.m, 12.3~18.8lb-ft)

5.
Remove the rear seat back assembly (A).
6.
Install in the reverse order of removal.
[Rear seat cushion assembly]
1.
Remove the trunk trim.
(1)
Remove the luggage cover board (A).
(2)
Remove the luggage box (A).
2.
Loosen the rear seat cushion mounting bolt (A).
Tightening torque :
16.7 ~ 25.5N.m (1.7 ~ 2.6kgf.m, 12.3~18.8lb-ft)

3.
Remove the rear seat cushion assembly (A) by pushing it up.
4.
Disconnect the heater cushion connector (A).
[LH]

[RH]
5.
Install in the reverse order of removal.
    Rear Seat Assembly Component Location
    1. Rear seat back assembly [LH] 2. Rear seat back assembly [RH] 3. Rear seat cushion assembly ...

    Rear Seat Back Cover Component Location
    1. Rear seat back cover [LH] 2. Rear seat back cover [RH] ...

    See also:

    Refrigerant Leak Test
    Always conduct a leak test with an electronic leak detector whenever leakage or refrigerant is suspected and when conducting service operations which are accompanied by disassembly or looseni ...

    SRS components and functions
    The SRS consists of the following components: 1. Driver's front air bag module 2. Passenger's front air bag module 3. Side air bag modules 4. Curtain air bag modules 5. Retractor pre- ...

    CVVT & Camshaft Installation
    1. Install the intake CVVT (A) to the intake camshaft. Tightening torque : 63.7 ~ 73.5 N.m (6.5 ~ 7.5 kgf.m, 47.0 ~ 54.2 lb-ft) ...