Kia Soul: CVVT Oil Control Valve (OCV). Repair procedures - Engine Control System - Engine Control / Fuel SystemKia Soul: CVVT Oil Control Valve (OCV). Repair procedures

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / CVVT Oil Control Valve (OCV). Repair procedures

Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and 2.
4.
Check that the resistance is within the specification.

Specification: Refer to “Specification”

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the CVVT oil control valve connector (A).
3.
Remove the mounting bolt (B), and then remove the valve from the engine.
[Bank 1 / Intake]

[Bank 1 / Exhaust]

Installation

  
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
  
Apply engine oil to the valve O-ring.
1.
Install in the reverse order of removal.

CVVT oil control valve installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    CVVT Oil Control Valve (OCV). Schematic Diagrams
    Circuit Diagram (M/T) (A/T) ...

    Variable Intake Solenoid (VIS) Valve. Description and Operation
    Description Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold. The ...

    See also:

    Heater Unit Component Location
    ...

    Floor mat anchor(s)
    When using a floor mat on the floor carpet, make sure it attaches to the floor mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward. WARNING - After market floor mat Do ...

    Transaxle Oil Temperature Sensor. Circuit Diagram
    ...