Kia Soul: Brake pedal Inspection - Chassis - MaintenanceKia Soul: Brake pedal Inspection

Kia Soul 2014-2019 PS Service Manual / Maintenance / Chassis / Brake pedal Inspection

Check that the brake pedal operates smoothly.
Brake Pedal Height and Stop Lamp Switch clearance Adjustment
1.
Disconnect the stop lamp switch connector (A).
2.
Adjust the brake pedal height (A) as illustration below.
Pedal height (A): 174.2 mm (6.86 in)
Full stroke (C): 108 mm (4.25 in)

3.
Adjust the stop lamp switch clearance (B).
Stop lamp clearance (B):
1.0 ~ 2.0 mm (0.04 ~ 0.08 in)
4.
Connect the stop lamp switch connector
    Brake lines, hoses and connections Inspection
    Visually check for proper installation, chafing, cracks, deterioration and any leakage Replace any deteriorated or damaged parts immediately. ...

    Chassis/Body nuts & bolts Inspection
    1. Tighten bolts and nuts on chassis and body. (1) Where necessary, tighten all the parts of the chassis. A. ...

    See also:

    Tire specification and pressure label
    The tires supplied on your new vehicle are chosen to provide the best performance for normal driving. The tire label located on the driver's side center pillar gives the tire pressures recommende ...

    Rear Seat Cushion Cover Component Location
    1. Rear seat cushion cover ...

    TPMS Sensor. Diagnosis procedure by using diagnostic device
    As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...