Kia Soul: Brake Booster. Installation - Brake System - Brake SystemKia Soul: Brake Booster. Installation

Kia Soul 2014-2019 PS Service Manual / Brake System / Brake System / Brake Booster. Installation

1.
Install in the reverse order of removal.
  
A.
Before installing the pin, apply the grease to the joint pin.
B.
Use a new snap pin whenever installing.
2.
After installing, bleed the brake system.
(Refer to Brake system bleeding)
3.
After be equipped perform bleeding air procedure in clutch release cylinder after pouring the brake fluid.
(Refer to Clutch - "Clutch Release Cylinder") - [MT only]
    Brake Booster. Inspection
    1. Inspect the check valve in the vacuum hose.    Do not remove the check va ...

    Master Cylinder. Components
    1. Reservoir cap 2. Reservoir 3. Grommet 4. Master cylinder ...

    See also:

    Power Relay Assembly (PRA) Repair procedures
    Removal     • Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure t ...

    Adjustment
    Inspect Glass Alignment 1. Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it. ...

    SS-B Solenoid Valve(ON/OFF). Inspection
    1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector (A). 3. Measure resistance bet ...