Kia Soul: Auto Light Sensor Removal
Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Auto Lighting Control System / Auto Light Sensor Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the photo & auto light sensor (A) from crash pad upper
side by using screw (-) driver.
|
| 3. |
Remove the auto light connector (B).
55555
|
Auto Light Sensor Inspection
In the state of IGN1 ON, when the multi function switch module detects
auto light switch on, tail lamp relay output and head lamp low relay output
are controlled according to auto light se ...
Auto Light Sensor Installation
1.
Reconnect the auto light connector.
2.
Install the auto light sensor.
...
See also:
Rear Torsion Beam Axle Inspection
1.
Check the hub for cracks and the splines for wear.
2.
Check the rear axle carrier for cracks.
...
Removal
1.
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
2.
Remove the tailgate back panel.
...
Tightening Torque
Items
N.m
Kgf.m
lb-ft
Front and rear doors
Door hinge to body
34.2 ~ 41.2
3.5 ~ 4.2
25.3 ~ 30.4
Door hinge to door
...