Kia Soul: Auto Light Sensor Inspection
Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Auto Lighting Control System / Auto Light Sensor Inspection
In the state of IGN1 ON, when the multi function switch module detects
auto light switch on, tail lamp relay output and head lamp low relay output
are controlled according to auto light sensor's input.
If IGN1 ON, The BCM monitors the range of this supply and raises up
a failure as soon as the supply’s voltage is out of range. Then this failure
occurs and as long as this is present, the head lamp must be turned on without
taking care about the sunlight level provided by the sensor.
This is designed to prevent any head lamp cut off when the failure
occurs during the night.
Auto Light Switch Inspection
1.
Operate the auto light switch, then check for continuity between
terminals of multi-function switch connector.
...
Auto Light Sensor Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the photo & auto light sensor (A) from crash pad upper
side ...
See also:
Rear Seat Assembly Replacement
[Rear seat back assembly]
1.
Detach the rear seat belt lower anchor (C) by pushing the lock
pin (B) of center mini buckle (A) with flat-tip driver.
...
Specification
Item
Specification
Current voltage
13V
Working voltage
DC 10~15V
Operating force
3.0kg Max
Volta ...
Panorama Sunroof Assembly Removal
•
In order to remove the panorama sunroof assembly, use
the tools shown in the followi ...