Kia Soul: Accelerator Position Sensor (APS). Repair procedures - Engine Control System - Engine Control / Fuel SystemKia Soul: Accelerator Position Sensor (APS). Repair procedures

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS). Repair procedures

Inspection

1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Specification: Refer to “Specification”
55555

Removal

1.
Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
2.
Disconnect the accelerator position sensor connector (A).
3.
Remove the mounting nuts (B).
4.
Remove the cap (A)
5.
Remove the mounting bolt (A), and then remove the accelerator pedal module.

Installation

1.
Install in the reverse order of removal.
Accelerator pedal module mounting nut:
12.8 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)
Accelerator pedal module mounting bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
    Accelerator Position Sensor (APS). Schematic Diagrams
    Circuit Diagram (M/T) (A/T) ...

    Fuel Tank Pressure Sensor (FTPS). Description and Operation
    Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge ...

    See also:

    Front Oil Seal Components
    1. Front oil seal ...

    Steering Column and Shaft. Disassembly
    Key lock assembly 1. Make a groove on the head of special bolts (A) by a punch. 2. Loosen the special bolt using a screw driver and ...

    Ashtray
    To use the ashtray, open the cover. To clean or empty the ashtray, pull it out. Do not use the vehicle’s ashtrays as waste receptacles. WARNING - Ashtray use Putting lit cigarettes or matches ...