Kia Soul: Replacement
|
|
1. |
Remove the head lamps.
(Refer to Body Electrical System - "Head Lamps")
|
2. |
Remove the A pillar garnish.
(Refer to Body Side Moulding - "A Pillar Garnish")
|
3. |
Remove the side sill moulding.
(Refer to Body Side Moulding - "Side Sill Moulding")
|
4. |
Using a clip remover, detach the clip, and remove the A pillar
guard (A).
|
5. |
Detach the clips and then remove the insulator pad (A).
|
6. |
Loosen the front wheel guard mounting screws and bolt.
|
7. |
Remove the front bumper side bracket (A) after loosening the screw
and bolt.
|
8. |
After loosening the mounting bolts and nut, then remove the fender
assembly (A).
|
9. |
Install in the reverse order of removal.
|
Component Location
1. Fender assembly ...Floor Carpet
...See also:
Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly
distribute the sealant in the tire.
Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...
Hazard Lamp Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center airvent assembly (A).
...
Exterior care
Exterior general caution
It is very important to follow the label directions when using any chemical cleaner
or polish. Read all warning and caution statements that appear on the label.
Finish mai ...