Kia Soul: Removal - Multifunction Switch - Body Electrical System - Kia Soul 2014-2019 PS Service ManualKia Soul: Removal

Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Multifunction Switch / Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel.
(Refer to Steering System - "Steering Wheel")
3.
Remove the steering column upper and lower shrouds.
(Refer to Body - "Steering Column Shroud Panel")
4.
Remove the clock spring.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
5.
Disconnect the light switch connector (A) and the wiper switch connector (B).

6.
Remove the wiper switch (A) by pushing the lock pin (B).
  
When removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.

7.
Loosen the screws from the multifunction switch assembly (A).

    Component
    ...

    Installation
    1. Install the multifunction switch. 2. Install the clock spring. 3. Install the stee ...

    See also:

    Vehicle break-in process
    No special break-in period is needed. By following a few simple precautions for the first 600 miles (1,000 km) you may add to the performance, economy and life of your vehicle. Do not race the ...

    Owner’s responsibility
    ✽ NOTICE Maintenance Service and Record Retention are the owner's responsibility. You should retain documents that show proper maintenance has been performed on your vehicle in accordan ...

    Battery Inspection
    Battery Terminal 1. Move back and forth to check that the battery terminals (A) are loose or corroded. If the terminals are corroded, clean them. ...