Kia Soul: Installation - Multifunction Switch - Body Electrical SystemKia Soul: Installation

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Multifunction Switch / Installation

1.
Install the multifunction switch.
2.
Install the clock spring.
3.
Install the steering column upper and lower shrouds.
4.
Install the steering wheel.
5.
Connect the negative (-) battery terminal.
  
Make sure the multifunction switch connectors are plugged in properly.
    Removal
    1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. (Refer to Steering System - "Steer ...

    Inspection
    Lighting Switch Inspection 1. With the multi function switch in each position, make sure that continuity exists between the terminals below. If conti ...

    See also:

    To increase cruise control set speed
    Follow either of these procedures: Push the RES + switch and hold it. Your vehicle will accelerate. Release the switch at the speed you want. Push the RES+ switch and release it immediately ...

    Checking the amount of air conditioner refrigerant and compressor lubricant
    When the amount of refrigerant is low, the performance of the air conditioning is reduced. Overfilling also has a negative impact on the air conditioning system. Therefore, if abnormal operation is ...

    35R Clutch Control Solenoid Valve(35R/C_VFS). Inspection
    1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor ...