Kia Soul: Removal
1. |
Disconnect the battery negative cable, and wait for at least thirty
seconds before beginning work.
|
2. |
To remove the emergency fastening device (C), keep on pushing
the lock pin (A) as arrow direction. And then remove the seat belt after
pushing the lock pin (B).
|
3. |
Remove the center pillar lower trim.
(Refer to Body - "Center pillar trim")
|
4. |
Remove the center pillar upper trim.
(Refer to Body - "Center pillar trim")
|
5. |
After loosening the mounting bolt, then remove the front seat
belt upper anchor (A).
|
6. |
Disconnect the seat belt pretensioner connector (A).
|
7. |
Loosen the seat belt pretensioner mounting bolt (B) and remove
the seat belt pretensioner.
|
Components
...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty
seconds.
...
See also:
Engine Room Under Cover Removal and Installation
Engine Room Under Cover
1.
Remove the engine room under cover (A).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft ...
Repair procedures
Replacement
1.
Remove the front bumper.
(Refer to Front Bumper - "Front Bumper Cover")
2.
Loosen the screws, and then remove the charge door open cover lamp (A).
3.
Disconnect the notific ...
Dynamic Damper Installation
1.
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper.
2.
Install the dynamic damper.
...