Kia Soul: Injector. Troubleshooting
Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Injector. Troubleshooting
Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The
top waveform is from the high side (feed side) of the #1 and #4 injectors, while
the middle waveform is from the low side (ground side) of the #1 injector and
the bottom waveform is from the low side of the #4 injector.
The middle waveform is the same as the top waveform because there is no
ground for the circuit. With no current flowing in the circuit, the #1 injector
is not energized and fuel does not flow.
The bottom waveform shows that ground is supplied and there is a voltage
drop across the #4 injector. With current flowing in the circuit, the #4 injector
is energized and fuel flows.
Injector. Specifications
Specification
Item
Specification
Coil Resistance (Ω)
1.5 ± 0.075 [20°C(68°F)]
...
Injector. Schematic Diagrams
Circuit Diagram
(M/T)
(A/T)
...
See also:
Use high quality ethylene glycol coolant
Your vehicle is delivered with high quality ethylene glycol coolant in the cooling
system. It is the only type of coolant that should be used because it helps prevent
corrosion in the cooling syst ...
Variable Intake Solenoid (VIS) Valve. Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance betwe ...
Steering Angle Sensor
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power
Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning directio ...