Kia Soul: Injector. Description and Operation - Engine Control System - Engine Control / Fuel SystemKia Soul: Injector. Description and Operation

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Injector. Description and Operation

Description

The GDI injector is similar to a standard injector, but sprays fuel at a much higher pressure directly into the combustion chamber and has a swirl disc to get the fuel swirling as it exits the nozzle. This aids in atomization of the fuel.The ECM controls both the feed circuits (high side) to feed voltage to the injectors and the ground circuits (low side) to energize the injectors. Also, the feed for 2 injectors comes from the same driver set. As the ignition coils are paired with cylinders (1-4 and 2-3), the injectors are also set up in pairs.

    Fuel Tank Pressure Sensor (FTPS). Repair procedures
    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the FTPS. Specifica ...

    Injector. Specifications
    Specification Item Specification Coil Resistance (Ω) 1.5 ± 0.075 [20°C(68°F)] ...

    See also:

    Field Effect Transistor (FATC) Replacement
    1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing. (Refer to Body - "Glove Box Housing") ...

    Illuminated ENGINE START/STOP button
    Whenever the front door is opened, the ENGINE START/STOP button will illuminate for your convenience. The light will go off after about 30 seconds when the door is closed. When all entrances ...

    Mode Control Actuator Description
    The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing ...