Kia Soul: Dynamic Damper Components
Kia Soul 2014-2019 PS Service Manual / Driveshaft and axle / Driveshaft Assembly / Dynamic Damper Components
1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot |
5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band |
9. TJ boot 10. Spider assembly 11. Snap ring 12. TJ housing |
13. TJ circlip |
TJ Joint Installation
1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
2.
Using the alignment marks (D) made during disassembly as a ...
Dynamic Damper Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refe ...
See also:
Rear Torsion Beam Axle Repair procedures
Replacement
1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from front hub.
Tightening torque :
88.2 ~ ...
Brake Pedal. Installation
1.
Pre-tighten the bracket fixing bolt (A) in dash panel.
2.
Install the brake booster and brake pedal member fixing nuts (A)
secur ...
Rear Wheel Speed Sensor. Components
1. Rear wheel speed sensor
2. Extension cable assembly
...