Kia Soul: Driver Airbag (DAB) Module and Clock Spring. Removal - Airbag Module - RestraintKia Soul: Driver Airbag (DAB) Module and Clock Spring. Removal

Kia Soul 2014-2019 PS Service Manual / Restraint / Airbag Module / Driver Airbag (DAB) Module and Clock Spring. Removal

1.
Set the front tires straight-ahead before removing the steering wheel.
  
If the steering wheel and the front tires are not set straight ahead together, it affects the number of circulation of steering wheel and the cable inside the clock spring is possible to be damaged.
2.
Disconnect the battery negative cable.
  
After disconnecting the battery negative cable, wait for at least thirty seconds.
3.
Release the connector locking pin, then disconnect the driver airbag module connector(B).
  
The removed airbag module should be stored in a clean, dry place with the pad cover facing up.
4.
Remove the steering wheel.
(Refer to Steering System - "Steering Column and Shaft")
5.
Loosen the screws and then remove the steering wheel column shroud (A).

6.
Disconnect the clock spring and horn connector (A) and then remove the clock spring.

    Driver Airbag (DAB) Module and Clock Spring. Components
    1. Driver Airbag (DAB) 2. Steering Wheel 3. Clock Spring ...

    Driver Airbag (DAB) Module and Clock Spring. Inspection
    Driver Airbag (DAB) If any improper parts are found during the following inspection, replace the airbag module with a new one.    ...

    See also:

    Manual heating and air conditioning
    The heating and cooling system can be controlled manually by pushing buttons other than the AUTO button. In this case, the system works sequentially according to the order of buttons selected. W ...

    SRS Control Module (SRSCM). Variant coding
    After replacing the SRSCM with a new one, MUST perform the “Variant Coding” procedure.    1. ...

    Side repeater light bulb Type A replacement (if equipped)
    1. Remove the light assembly from the vehicle by prying the lens and pulling the assembly out. 2. Disconnect the bulb electrical connector. 3. Separate the socket and the lens parts by turning ...