Kia Soul: Driver Airbag (DAB) Module and Clock Spring. Inspection - Airbag Module - RestraintKia Soul: Driver Airbag (DAB) Module and Clock Spring. Inspection

Kia Soul 2014-2019 PS Service Manual / Restraint / Airbag Module / Driver Airbag (DAB) Module and Clock Spring. Inspection

Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace the airbag module with a new one.
  
Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious personal injury.
1.
Check pad cover for dents, cracks or deformities.
2.
Check the airbag module for denting, cracking or deformities.
3.
Check hooks and connectors for damage, terminals for deformities, and harness for binds.
4.
Check airbag inflator case for dents, cracks or deformities.

5.
Install the airbag module to the steering wheel to check for fit or alignment with the wheel.
Clock Spring
1.
If, as a result of the following checks, even one abnormal point is discovered, replace the clock spring with a new one
2.
Check connectors and protective tube for damage, and terminals for deformities.

    Driver Airbag (DAB) Module and Clock Spring. Removal
    1. Set the front tires straight-ahead before removing the steering wheel.    ...

    Driver Airbag (DAB) Module and Clock Spring. Installation
    1. Set the front tires straight-ahead before assembling the steering wheel.    ...

    See also:

    Components and Components Location
    Components (1) 1. Rear door pull cap 2. Rear door inside handle cap 3. Rear door delta inner cover 4. Rear door trim 5. Rear door belt inside weatherstrip 6. Rear door pane ...

    Fuel requirements
    Your new vehicle is designed to use only unleaded fuel having a pump octane number ((R+M)/2) of 87 (Research Octane Number 91) or higher. Your new vehicle is designed to obtain maximum performance ...

    Portable lamp usage (if equipped)
    1. In-vehicle lamp, if necessary, after separation can be used as a portable. 2. Press push button (1). 3. Pull out the lamp holder. 4. Press the power switch (2). CAUTION 1. Remove the batte ...