Kia Soul: Water Temperature Control Assembly Removal and Installation - Cooling System - Engine Mechanical SystemKia Soul: Water Temperature Control Assembly Removal and Installation

Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly Removal and Installation

1.
Remove the engine cover.
2.
Drain the engine coolant.
(Refer to Cooling System - "Coolant")
3.
Remove the air cleaner assembly.
(Refer to Intake And Exhaust System - “Air Cleaner”)
4.
Disconnect the water temperature sensor connector (A).
5.
Disconnect the radiator upper hose and the heater hose from the water temperature control assembly.
6.
Disconnect the water hose (A) and then remove the water temperature control assembly (B) with the O-ring.
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

7.
Install in the reverse order of removal.
  
•
Install a new O-ring when replacing the water temperature control assembly.
•
Clean the surface of the new O-ring, wet it with water and then install it.
8.
Fill the engine coolant.
(Refer to Cooling System - "Coolant")
9.
Start the engine and check for leaks.
    Water Temperature Control Assembly Components
    1. Water temperature assembly 2. Water temperature sensor 3. Gasket 4. Heater pipe ...

    Water pump Components
    1. Gasket 2. Water pump 3. Water pump pulley ...

    See also:

    Rear Door Inside Handle Replacement
    1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Loosen the rear door inside handle mounting screws ( ...

    [CVVT System Mode]
    (1) Low Speed / Low Load (2) Part Load (3) Low Speed / High Load (4) High Speed / High Load ...

    Summer tires
    Kia specifies summer tires on some models to provide superior performance on dry roads. Summer tire performance is substantially reduced in snow and ice. Summer tires do not have the tire traction ...