Kia Soul: Water pump Inspection - Cooling System - Engine Mechanical SystemKia Soul: Water pump Inspection

Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Cooling System / Water pump Inspection

1.
Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary.
2.
Check the bearing for damage, abnormal noise and sluggish rotation, and replace the coolant pump assembly if necessary.
3.
Check for coolant leakage. If coolant leaks from hole, the seal is defective. Replace the coolant pump assembly and gasket.
  
A small amount of “weeping” from the bleed hole is normal.
    Water pump Removal
    1. Drain the coolant. (Refer to Cooling System - "Coolant") 2. Remove the drive belt. (Refer to Timing System - " ...

    Water pump Installation
    1. Install the new gasket and water punp(A). Tightening torque : 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft) ...

    See also:

    Ending voice recognition
    While Voice Recognition is operating Press and hold the key on the steering remote controller While using voice command, pressing any steering wheel control or a different key will end vo ...

    Power steering pump, belt and hoses (if equipped)
    Check the power steering pump and hoses for leakage and damage. Replace any damaged or leaking parts immediately. Inspect the power steering belt (or drive belt) for evidence of cuts, cracks, exce ...

    Schematic Diagram
    Canister The Canister is filled with charcoal and absorbs evaporated fuel vapor from the fuel tank. The gathered fuel vapor in canister is drawn into the intake manifold by the ECM/PC ...