Kia Soul: Variable Intake Solenoid (VIS) Valve. Repair procedures
Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve. Repair procedures
Inspection
1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the VIS valve connector.
|
3. |
Measure resistance between VIS valve terminals 1 and 2.
|
Removal
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the variable intake solenoid valve connector (A).
|
3. |
Disconnect the vacuum hoses (B) from the valve.
|
4. |
Remove the valve (C) from the surge tank.
|
Installation
|
|
1. |
Install in the reverse order of removal.
|
Variable Intake Solenoid (VIS) Valve. Schematic Diagrams
Circuit Diagram (M/T) (A/T) ...Fuel Pressure Control Valve. Description and Operation
Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on ...See also:
Information
Press the
key
Set [
Info]
through the
TUNE knob or
key.
Displays information of the current song.
❈ Press the
key to turn off info display. ...
Installation
1.
Install in the reverse order of removal.
2.
After be equipped, perform bleeding air procedure in clutch release
cylinder after pouring t ...
Limp Home Function
1.
Limp Home By Tester
If the PCM(ECM) detects the fault of the SMARTRA or transponder,
the PCM(ECM) will allow limp home function of the immobilizer. Limp ...