Kia Soul: Troubleshooting
Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Troubleshooting
Symptom |
Suspect Area |
Remedy (Refer to page) |
Water leaks from panorama sunroof |
Deteriorated roof lid weatherstrip |
Replace |
Excessive roof lid-to-body clearance and improperly fitted weatherstrip |
Adjust |
|
Wind noise around panorama sunroof |
Loose or deformed deflector, gaps in body work |
Retighten adjust or replace |
Noise heard when opening/ closing panorama sunroof |
Foreign particles lodged in guide rail |
Check drive cable and guide rails for foreign particles |
Loose guide rails and lid |
Retighten |
|
Motor runs but panorama sunroof does not move or moves only
partially |
Foreign particles lodged in guide rail |
Adjust or replace |
Incorrect engagement of motor pinion with drive cable |
||
Decrease in motor`s clutch slipping force |
||
Increased panorama sunroof sliding resistance or interference
of panorama sunroof with drive cables, weatherstrip, etc. due tomal adjustment
of panorama sunroof |
||
Noise in motor (clutch slipping noise from motor when panorama
sunroof is fully opened or closed is not an unusual noise |
Incorrect engagement of motor pinion with drive cable |
Check pinion installation and |
Re-tighten motor |
||
Worn out or damaged motor pinion bearing |
Replace motor assembly |
|
Worn out or deformed drive cable |
Replace |
|
Door glass fails to operate up and down |
Incorrect window glass installation |
Adjust position |
Damaged or faulty regulator arm or regulator |
Correct or replace |
|
Door does not open or close completely |
Incorrect door installation |
Adjust position |
Defective door check assembly |
Correct or replace |
|
Door hinge requires grease |
Apply grease |
|
Hood does not open or close completely |
Striker and latch not properly aligned |
Adjust |
Incorrectly installed hood |
Adjust |
|
Incorrect hood bumper height |
Adjust |
|
Water leak through windshield end rear window |
Defective seal |
Fill with sealant |
Defective flange |
Correct |
Special Service Tools
Tool Name / Number Illustration Description Hog ring clip installer 09880-4F000 ...Body Dimensions
...See also:
Drive Belt Tensioner Removal and Installation
1.
Remove the drive belt.
(Refer to Timing System - "Dreve Belt")
2.
Remove the alternator.
(Refer to Engine Electrica ...
Front seat adjustment - manual
Forward and backward
To move the seat forward or backward:
1. Pull the seat slide adjustment lever up and hold it.
2. Slide the seat to the position you desire.
3. Release the lever and make s ...
Remote keyless entry system operations
Lock (1)
1.Close all doors, engine hood and tailgate.
2.Press the lock button(1).
3.All doors and tailgate will lock. The hazard warning lights will blink once.
4.If the lock button is pressed o ...