Kia Soul: Transmitter Code Registration (Using GDS)
1. |
Connect the DLC cable of GDS to the data link connector (16
pins) in driver side crash pad lower panel, turn the power on GDS.
|
2. |
Select the vehicle model and then do "CODE SAVING"
|
3. |
After selecting "CODE SAVING" menu, button "ENTER" key, then
the screen will be shown as below.
|
4. |
After removing the ignition key from key cylinder, push "ENTER"
key to proceed to the next mode for code saving. Follow steps 1
to 4 and then code saving is completed.
|
Transmitter Inspection
1. Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. 2. Remove the batt ...Lighting System
...See also:
High mounted stop light replacement
1. Open the tailgate.
2. Remove the cover.
3. Loosen the retaining bolts.
Bulb type
4. Pull out the module from the high mounted stop light assembly by pulling both
clips.
5. Replace th ...
Loss of the smart key
A maximum of 2 smart keys can be registered to a single vehicle.
If you happen to lose your smart key, you will not be able to start the engine.
You should immediately take the vehicle and remainin ...
Installtion
1.
With a knife, scrape the old adhesive smooth to a thickness of
about 2mm (0.08 in.) on the bonding surface around the entire windshield
opening flange:
...