Kia Soul: TPMS Receiver Replacement
Kia Soul 2014-2019 PS Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Receiver Replacement
When the receiver first arrives for replacement:
|
It is important to make sure that the correct receiver is used
to replace the faulty part i.e. it must be Low Line and not High Line
in order to have the correct inflation warning thresholds set.
|
1. |
Disconnect vehicle battery.
|
2. |
Remove the crash pad garnish.
(Refer to BD group - "Crash Pad")
|
3. |
Remove the receiver with bracket.
|
4. |
Install in the reverse order of removal.
|
5. |
Re-connect battery and turn Ignition on.
|
6. |
After replacing the receiver, learn by using self-diagnosis device(GDS).
|
[Wheel Sensor ID Writing (Wireless) initialization]
[Wheel Sensor ID Writing (Wireless) 1]
[Wheel Sensor ID Writing (Wireless) 2]
TPMS Receiver Operation
1. General Function A. Auto-learn takes place only once per Ignition cycle. B. On successful compl ...TPMS Receiver. Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...See also:
Starter Reassembly
1.
Reassemble in the reverse order of disassembly.
...
Door Scuff Trim Component Location
1. Front door scuff trim
2. Rear door scuff trim
...
Certification label
The certification label is located on the driver's door sill at the center pillar.
This label shows the maximum allowable weight of the fully loaded vehicle. This
is called the GVWR (Gross ...