1. |
Mode
(1) |
Virgin State
A. |
The receiver as a sole part is shipped in this
state. Replacement parts should therefore arrive in
this state.
|
B. |
In this state, there is no sensor monitoring and
no DTC monitoring.
|
C. |
The state indicates that platform specific parameters
must be written to the receiver and that sensors are
un-learned.
|
|
(2) |
Normal State
A. |
In order for tire inflation state and DTC monitoring
to occur, the receiver must be in this state.
|
B. |
In this state, automatic sensor learning is enabled.
|
|
(3) |
Test State
A. |
This state is only used in manufacturing plant
to check RF transmission between sensor and receiver.
|
|
|
2. |
Overview
A. |
Receives RF data from sensor.
|
B. |
Uses sensor data to decide whether to turn on TREAD Lamp.
|
C. |
Learn TPM sensor for under inflation monitoring automatically.
|
D. |
Uses sensor information, distance travelled, background
noise levels, Auto-learn status, short / open circuit output
status, vehicle battery level, internal receiver states to determine
if there is a system or a vehicle fault.
|
|
As manual for diagnosis methods by using diagnosis device, the main contents
are as follows:
1.
Connect self-diagnosis connector(16pins) located in the lower
of driv ...
1.
General Function
A.
Auto-learn takes place only once per Ignition cycle.
B.
On successful compl ...
See also:
Push-starting
Vehicles equipped with automatic transaxle and manual transaxle vehicles equipped
with clutch lock system cannot be push-started.
Follow the directions in this section for jump-starting.
WARNING - ...
Inspection
Signal Circuit Inspection
1.
Check ignition lock switch pull-up voltage
(1)
IG KEY "OFF", ENGINE "OFF".
...
Luggage room lamp
The luggage room lamp comes on when the tailgate is opened.
The lamp comes on as long as the tailgate is open. To prevent unnecessary charging
system drain, close the tailgate securely after usin ...