1. |
Perform spark test
(1) |
Remove the engine cover.
|
(2) |
Remove the ignition coils.
|
(3) |
Remove the spark plugs.
|
(4) |
Disconnect the 4 injector connectors.
|
(5) |
Connect the spark plug to the ignition coils.
|
(6) |
Ground the spark plug to the engine.
|
(7) |
Check if sparks occur at each spark plug while engine
is being cranked.
Do not crank the engine for more then 5 seonds.
|
|
(8) |
Connect the 4 injector connectors.
|
(9) |
Install the spark plugs and ignition coils.
|
(10) |
Install the cylinder head center cover and engine cover.
|
|
2. |
Check spark plug
(1) |
Using an ohmmeter, measure the insulation resistance.
Specification:
10 MΩ or more
|
|
(2) |
Alternative inspection method
A. |
Accelerate the enigne to about 3,000 rpm 3 times
or more.
|
B. |
Remove the spark plug.
|
C. |
Check the spark plug visually.
If the electrode is dry, the spark plug is normal.
If the electrode is wet, check the damage and
electrode gap.
|
D. |
Install the spark plug.
|
|
(3) |
Check the spark plug electrode gap.
If the gap is not within the specification below, replace
the spark plug.
Specification:
0.9 ~ 1.0 mm (0.035 ~ 0.039 in.)
|
When adjusting the gap of a new spark plug, bend
only the base of the ground electrode. Do not touch
the tip.
Do not attempt to adjust the gap of a used plug.
|
|
|
1.
Remove the engine room under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
2.
Drain the manual tra ...
1.
Remove the ignition coil.
2.
Using a spark plug wrench, remove the spark plug (A).
...
See also:
Explanation of scheduled maintenance items
Engine oil and filter
The engine oil and filter should be changed at the intervals specified in the
maintenance schedule. If the vehicle is being driven in severe conditions, more
frequent oil an ...
Component Location
1. Quarter fixed glass
...
Front fog light (if equipped)
Fog lights are used to provide improved visibility when visibility is poor due
to fog, rain or snow, etc. The fog lights will turn on when the fog light switch
(1) is turned to the on position ...