Kia Soul: Smart Key Unit Removal
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the main crash pad assembly.
(Refer to Body - "Main Crash Pad Assembly")
|
3. |
Loosen the mounting bolts and nut from the smart key unit
bracket.
|
4. |
Remove the smart key unit (B) after disconnecting the connector
(A) from the smart key unit.
|
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the floor console assembly.
(Refer to Body - "Floor Console Assembly")
|
3. |
Disconnect the connector (A) from the interior antenna.
|
4. |
Remove the interior antenna (A) after loosening the mounting
nuts.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the rear seat cushion assmebly.
(Refer to Body - "Rear Seat Assembly")
|
3. |
Remove the interior antenna 2 (A). (in the order as below)
|
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
|
3. |
Disconnect the connector (A), then remove the rear bumper
antenna (B) with loosening the mounting screws.
|
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the front left wheel guard.
|
3. |
Remove the buzzer (B) after disconnecting the connector (A).
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door module.
(Refer to Front Door - "Front Door Module")
|
3. |
Remove the hole plug (A).
|
4. |
After loosening the mounting bolt, then remove the front door
outside handle cover (B).
|
5. |
Remove the front door outside handle (A) by sliding it rearward.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the tailgate trim.
(Refer to Body - "Tail Gate Trim")
|
3. |
Disconnect the tailgate open switch connector (A).
|
4. |
Remove the tailgate switch (A).
|
Smart Key Unit Inspection
Smart Key Unit - Refer to Smart key System - "Smart key Diagnostic" Smart Key Switch - Refer to Smart ke ...Smart Key Unit Installation
Smart Key Unit 1. Install the smart key unit. 2. Connect the connector and install the smart key unit. ...See also:
Torque Converter Control Solenoid Valve (T/CON_VFS). Removal
1.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
2.
Remove the drain plug (A) and dr ...
Refrigerant Leak Test
Always conduct a leak test with an electronic leak detector whenever leakage
or refrigerant is suspected and when conducting service operations which are
accompanied by disassembly or looseni ...
ETC (Electronic Throttle Control) System. Specifications
Specification
[TPS1]
Item
Opening Percentage
(%)
Output Voltage (V)
[Vref = 5V]
C.T
7 ~ 13
0.35 ~ 0.65
W.O.T
88.6 ~ 94
...