Kia Soul: Seat Belt Buckle Switch (BS). Installation - SRSCM - RestraintKia Soul: Seat Belt Buckle Switch (BS). Installation

Kia Soul 2014-2019 PS Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS). Installation

  
Be sure to install the harness wires not to be pinched or interfered with other parts.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the ignition key from the vehicle.
3.
Install the seat belt buckle switch.
Tightening Torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
4.
Install the front seat assembly.
(Refer to the Body - "Seat")
5.
Reconnect the battery negative cable.
6.
After installing the Seat Belt Buckle Switch, confirm proper system operation:
A.
Turn the ignition switch ON, the SRS indicator should be turned on for about six seconds and then go off.
    Seat Belt Buckle Switch (BS). Removal
    1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front passenger seat as ...

    Occupant Detection System (ODS). Description
    In order to make normal activation of airbag system, SRSCM detects DTC(s) for the Passenger side Body Detection System. If the seat is occupied, Body sensor detects how measuring electrostati ...

    See also:

    Engine Coolant Temperature Sensor (ECTS). Description and Operation
    Description Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant passage of the cylinder head for detecting the engine coolant temperature. The ECTS uses a thermistor th ...

    For best battery service
    Keep the battery securely mounted. Keep the battery top clean and dry. Keep the terminals and connections clean, tight, and coated with petroleum jelly or terminal grease. Rinse any spil ...

    Operation in foreign countries
    If you are going to drive your vehicle in another country, be sure to: Observe all regulations regarding registration and insurance. Determine that acceptable fuel is available. ...