Kia Soul: Removal
1. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air cleaner")
|
2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
|
3. |
Remove the ground line after removing the bolt (A).
|
4. |
Dissconnect the solenoid valve connector (A) and inhibitor switch
connector (B).
|
5. |
Remove the wiring brackets (A, B, C).
|
6. |
Remove the shift cable (C) after removing the nut (A) and bolts
(B).
|
7. |
Disconnect the hose (B) after removing the automatic transaxle
fluid cooler hose clamp (A).
|
8. |
Remove the automatic transaxle upper mounting bolts (A) and the
starter mounting bolts (B).
|
9. |
Install the engine support fixture.
|
10. |
Remove the cover (A).
|
11. |
Remove the transaxle mounting bracket bolts (A).
|
12. |
Remove the transaxle support bracket (A).
|
13. |
Lift the vehicle with a jack.
|
14. |
Remove the under cover and side cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
|
15. |
Remove the drive shaft assembly.
(Refer to Driveshaft and Axle - "Front Driveshaft")
|
16. |
Remove the heat protector (A).
|
17. |
Remove the air guide bracket (A).
|
18. |
Remove the dust cover (A).
|
19. |
Remove the torque converter mounting bolts (A) with rotating the
crankshaft.
|
20. |
Remove the roll rod bracket (C) after removing bolts (A, B).
|
21. |
Remove the mounting bolts (A, B) after supporting the transaxle
by a jack.
|
22. |
Remove the transaxle while slowly lower the jack.
|
Components Location
1. Converter housing 2. Automatic transaxle upper mounting bolt 3. Shift cable bracket 4. Manual control lever 5. Rear cover 6. Fluid cooler tube 7. Fluid level plug 8. ...Installation
1. Install in the reverse order of removal. If the oil seal on the transaxle case side is d ...See also:
Refrigerant Line Replacement
1.
Discharge refrigerant from the refrigeration system.
2.
Replace faulty tube or hose.
...
Maintenance services
You should exercise the utmost care to prevent damage to your vehicle and injury
to yourself whenever performing any maintenance or inspection procedures.
Should you have any doubts concerning the ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS). Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector (A).
3.
Measure resistance bet ...