Kia Soul: Rear Oil Seal Installation - Cylinder Block - Engine Mechanical SystemKia Soul: Rear Oil Seal Installation

Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Installation

1.
Install the rear oil seal.
(1)
Apply engine oil to a new oil seal lip.
(2)
Using the SST(09231-H1100, 09231-2B200) and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

2.
MT : Install the flywheel.
(Refet to Cylinder Block - "Flywheel")
3.
AT : Install the drive plate.
(Refet to Cylinder Block - "Drive Plate")
4.
Install the transaxle assembly.
(Refer to Manual Transaxle System - "Manual Transaxle")
(Refer to Automatic Transaxle System - "Automatic Transaxle")
    Rear Oil Seal Removal
    1. Remove the transaxle assembly. (Refer to Manual Transaxle System - "Manual Transaxle") (Refer to Automatic Transaxle System - "Automatic Transa ...

    Piston and Connecting Rod Components
    1. Piston ring 2. Piston 3. Piston pin 4. Connecting rod 5. Connecting rod upper bearing 6. Connecting rod lower bearing 7. Connecting rod bearing cap ...

    See also:

    26 Brake Control Solenoid Valve(26/B_VFS). Inspection
    1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector (A). 3. Measure resistance bet ...

    Engine Mounting Removal and Installation
    Engine Mounting Bracket 1. Remove the engine room under cover. (Refer to Engine And Transaxle Assembly - "Engine Room Under Cover") 2. ...

    Condenser Replacement
    1. Recover the refrigerant with a recovery/recycling/charging station. 2. Disconnect the negative (-) battery terminal. 3. ...