Kia Soul: Rear Door Module Replacement - Rear Door - Body (Interior and Exterior)Kia Soul: Rear Door Module Replacement

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Module Replacement

1.
Remove the rear door window glass.
(Refer to Rear Door - "Rear Door Window Glass")
2.
Remove the rear door outside handle.
(Refer to Rear Door - "Rear Door Outside Handle")
3.
After loosening the mounting bolt and nuts, then remove the rear door channel (A).
Tightening torque :
Bolt : 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
Nut : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

4.
Disconnect the rear door main connector (A).
5.
Loosen the rear door outside handle base mounting bolt (A).
6.
Loosen the rear door latch (A) mounting screws.
7.
After loosening the mounting bolts, then remove the rear door module (B).
Tightening torque :
Bolt : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Screw : 7.8 ~ 10.8 N.m (0.8 ~ 1.1 kgf.m, 5.8 ~ 8.0 lb-ft)

8.
Remove the rear door main connector mounting clips (A).
9.
Remove the rear door module wiring harness mounting clips (A).
10.
Disconnect the rear door latch connector (A) and then remove the mounting clip (B).
11.
Disconnect the connectors and rear door module wiring harness (A).
12.
Remove the rear door latch assembly.
(Refer to Rear Door - "Rear Door Latch")
13.
Reomove the rear speaker .
(Refer to Body Electrical System - "Speakers")
14.
Remove the rear power window motor.
(Refer to Body Electrical System - "Power Window Motor")
15.
Install in the reverse order of removal.
  
•
The area of whole parts should be applied with sufficient grease.
•
Make sure connectors are connected properly and each rod is connected securely.
•
Make sure the door locks/unlocks and opens/closes properly
    Rear Door Module Component Location
    1. Rear door module ...

    Rear Door Outside Handle Component Location
    1. Rear door outside handle ...

    See also:

    1. Crankcase emission control system
    The positive crankcase ventilation system is employed to prevent air pollution caused by blow-by gases being emitted from the crankcase. This system supplies fresh filtered air to the crankcase th ...

    Camshaft Position Sensor (CMPS). Description and Operation
    Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and detects the ...

    Seat height (for driver’s seat)
    To change the height of the seat, push the lever upwards or downwards. To lower the seat cushion, push down the lever several times. To raise the seat cushion, pull up the lever several times. ...