Kia Soul: Rear Bumper Cover Replacement - Rear Bumper - Body (Interior and Exterior)Kia Soul: Rear Bumper Cover Replacement

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper Cover Replacement

  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
After loosening the mounting screws, then remove the rear combination lamp (A).

2.
Disconnect the rear combination lamp connector (A).

3.
Loosen the rear bumper upper mounting clip (A).

4.
Loosen the mounting bolts (A).

5.
Disconnect the rear bumper main connector (A).

6.
After loosening the rear bumper side's mounting screws and clip, then disconnect the side's.
  
•
Remove the rear bumper by pulling up the side of the rear bumper and then pull it out.
  
•
When you pull out the front bumper, the side part of the rear bumper could be damaged by the projection.

7.
Remove the rear bumper cover (A).

8.
Install in the reverse order of removal.
  
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.
    Rear Bumper Cover Component Location
    1. Rear bumper cover ...

    Rear Bumper Beam Assembly Component Location
    1. Rear bumper beam assembly ...

    See also:

    Panoramic sunroof
    If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof glass control lever located on the overhead console (1). The sunroof can only be opened, closed, ...

    Installing a child restraint on a front passenger’s seat is forbidden
    Never place a rear-facing child restraint in the front passenger’s seat. If the air bag deploys, it would impact the rear-facing child restraint, causing serious or fatal injury. In addition, ...

    Cruise Control Switch Installation
    1. Install in the reverse order of removal. ...